- [email protected]
- Unit 1 Brooks Lane, Middlewich, Cheshire
- 020 8075 5838
Tankless Series
MODEL MSE
MODEL MSE
SHIPBOARD ELECTRIC WATER HEATER
6-120 GALLON CAPACITY, UP TO 58 KW, SINGLE- OR THREE-PHASE
The TWS Model MSE water heater is specifically designed for marine use and is in conformance with the USCG and is ABS type approved. By utilising deck and bulkhead mounting supports, the water heater is securely fastened to the ship structure, thus providing a secure and reliable water heater installation. To ensure tank longevity, the high-quality tank is constructed of steel and internally lined with specially formulated hydrastone cement.
The Hydrastone Cement lining, along with solid copper-silicon threaded tank openings and a built-in heat trap device, all ensure a longer-lasting, energy-efficient water heater that is resistant to the highly corrosive effects of hot water.
When you specify and install a TWS model MSE, knowing that it is in conformance with USCG regulations and ABS type approved, you will have confidence that the shipowner will be provided with a long-lasting, trouble-free source for hot water.
Download the MODEL-MSE Brochure Below:
Model MSE
USCG CONFORMANCE AND ABS TYPE APPROVED
SECURE AND RELIABLE INSTALLATION
HORIZONTAL OR VERTICAL CONFIGURATIONS AVAILABLE
HYDRASTONE CEMENT LINING
CORROSION-FREE COPPER-SILICON TAPPINGS
POLYURETHANE FOAM INSULATION
BUILT-IN HEAT TRAP
HX/TX Overview
GENERAL
- 1/2″ thick HydraStone cement lining
- Removable bulkhead attachment points
- Heavy-duty integrally welded leg supports for deck mounting
- Non-ferrous solid copper-silicon threaded openings for maximum corrosion resistance
- Magnetic contactor(s) are heavy-duty resistive load type rated for 200,000 cycles
- Low-voltage control circuit (fused) transformer (units over 240 volts)
- Power circuit fuse protection (units over 48 amp)
- Incoloy sheathed immersion heating elements
- Built-in heat trap to improve operating efficiency (3/4″ only)
- Surface thermostat 110-170°F range
- Immersion thermostat (100-190°F) furnished as standard when required due to high recovery versus storage ratio.
o On 6-30 gallon heaters over 5 kW
o On 40 and 50-gallon heaters over 8 kW
o On 65-gallon heaters over 12 kW
o On 80-119 gallon heaters over 15 kW
- Surface safety hi-limit cut out with manual reset button (190°F)
- Immersion safety hi-limit cut out with manual reset button (Standard on heaters 45 kW and above)
- ASME-rated temperature and pressure relief valve set at 100 psi, 210°F
- 2″ thick polyurethane foam insulation
- High-impact non-corroding colorized composite protective jacket
- Cold water inlet diffuser with drain valve
